Revive Dead LED Bulbs with Super Glue: A Simple Trick That Will Amaze You

LED bulbs are known for their energy efficiency and long lifespan. However, like any other electrical appliance, LED bulbs can fail and stop working. The good news is that there are some simple repair tricks that you can try at home before you throw away your dead LED bulb.

 

One of the easiest and most effective ways to revive a dead LED bulb is by using super glue and baking soda. This simple repair trick requires no tools or soldering welding, and it can save you the cost of buying a new LED bulb.

 

To start, you will need to gather a few materials. These include super glue, baking soda, and a small brush or toothbrush. You may also need a small amount of water to moisten the brush.

 

First, remove the dead LED bulb from its socket and inspect it for any signs of damage or corrosion. If there are any visible signs of damage, such as a broken filament or a corroded contact, this repair trick may not work.

 

Next, apply a small amount of super glue to the dead LED bulb. Be careful not to apply too much glue, as this can interfere with the bulb’s electrical connection. Then, sprinkle a small amount of baking soda onto the glue.

 

Using the brush, gently spread the baking soda over the glue, making sure to cover the entire surface of the bulb. The baking soda will react with the glue, creating a hard, white coating on the bulb’s surface.

 

Allow the glue and baking soda to dry completely, which usually takes about 30 minutes. Once the coating is dry, reinsert the LED bulb into its socket and turn on the power. You should see the bulb light up, indicating that the repair trick has worked.

 

It is important to note that this repair trick may not work for all dead LED bulbs. If the bulb has been damaged beyond repair, it will not be possible to revive it using this method. Additionally, if the bulb continues to flicker or fail after the repair, it may be time to replace it.

 

In conclusion, if you have a dead LED bulb, don’t throw it away just yet. Try this simple repair trick using super glue and baking soda. With a little bit of patience and effort, you may be able to revive your dead LED bulb and save yourself the cost of buying a new one.

 

 

 

 

 

 

 

 

Leave a Reply

Your email address will not be published. Required fields are marked *